Concept Design · Building operations

Automating chilled-water plant across a campus

Link BMS trends, plant sequencing, operator overrides and maintenance so each building can run efficiently within its own operating limits.

The operating problem

A campus can have a functioning BMS in every building and still operate its chillers inefficiently. A teaching building has timetable peaks, a research building carries an overnight load, and replacement equipment may run against a sequence written for retired plant. Portfolio energy totals hide which combination of chillers, pumps and towers served a given load.

System landscape

A supported building management system (BMS) provides commanded and proved states. Meters provide the energy baseline. Local controllers run the equipment. The facilities team records overrides and maintenance.

Proposed architecture

Build a per-plant point register from as-built controls drawings, meters, equipment schedules and BMS trends. Link command, proven status, power, water temperatures, flow, equipment availability and override state. Validate units, intervals and sensor plausibility with the controls contractor. Use supported BMS interfaces, including BACnet where the installed controller supports it. Existing controllers retain equipment protection and local interlocks.

System responsibilities and interfaces
  1. BMS + metersStatus, command, flow and energy
  2. Supervisory analysisValidate trends and compare feasible operation
  3. Controls engineerApprove changes and verify fallback
  4. BMS + facilitiesCommissioned change and independent measurement
Event sequence Select a step for details
  1. Source recordsMetered load, equipment status and BMS trends
  2. ProcessingBuild and test a plant-specific supervisory sequence
  3. Decision ownerControls engineer and facilities operator approve change
  4. Operational outputCommissioned BMS operation and measured performance

An Australian campus benchmark

Exergenics reports optimising fourteen chilled-water plants at the University of Melbourne. For nine plants with a full year of measurement and verification, it reports 426 MWh in annual savings and an average measured saving of 11.1%. Those are the published project’s figures. The buyer’s case depends on its own plant, meter boundary and baseline.

From individual buildings to an operating portfolio

Start with one well-metered plant and a controls contractor who can access the current sequence. Review measured results with facilities and the energy manager. For the next building, reuse naming conventions, monitoring and acceptance tests, while re-identifying equipment, control authority and local conditions. A research lab and a lecture hall must not inherit one another’s operating limits.

Reliability and operating controls

A failed flow meter, a chiller taken out for maintenance or an active operator override changes what the supervisory sequence may do. Use the controls team’s commissioned fallback for loss of supervisory communications. Retain the prior sequence, disable further optimisation when prerequisites fail, and record operator authority and the reason for any override.

Illustrative operating scenario

During a teaching break, one building’s load falls while a research wing remains occupied. The shared plant is running an equipment combination tuned for the normal timetable. The controls team compares feasible combinations against the observed load, tests the approved sequence and verifies that the research spaces stayed within their site-defined requirements.

Delivery boundaries

The integration scope covers mapping, data quality, monitoring, change evidence and analysis. The client’s qualified controls engineer owns sequence changes, equipment protection, interlocks and witnessed commissioning. The energy manager owns the measurement boundary.

Expected business impact

Facilities could identify which plants run inefficiently under comparable conditions and decide where a controls change is justified. Track cooling service, plant availability and measured energy together.

Acceptance test and handover

Define the meter boundary with the energy manager. Compare plant input energy with cooling delivered under comparable weather, loads and occupancy. Keep maintenance periods, equipment changes and overrides visible. Set service criteria and an agreed baseline before claiming savings.

Commission under representative load conditions with the authorised controls contractor. Prove loss-of-signal fallback, manual control and return to normal before rolling out. Review service complaints, plant starts, availability and measured energy at the agreed boundary. Operations receives the trend definitions, change record, fallback procedure and seasonal review schedule.

Industry evidence

Exergenics · University of Melbourne chilled-water optimisation

CSIRO · Chiller optimisation research and application

Australian Government · Building management systems for HVAC

Discuss a similar workflow More building operations cases